北京邮电大学学报

  • EI核心期刊

北京邮电大学学报 ›› 2017, Vol. 40 ›› Issue (2): 93-96.doi: 10.13190/j.jbupt.2017.02.015

• 研究报告 • 上一篇    下一篇

基于平行耦合线和开路枝节的小型带通滤波器设计

喇东升1,2, 郭经纬3, 刘妍4, 贾守卿1, 马雪莲1   

  1. 1. 东北大学 计算机科学与工程学院, 沈阳 110819;
    2. 东南大学 毫米波国家重点实验室, 南京 210096;
    3. 燕山大学 信息科学与工程学院, 河北 秦皇岛 066004;
    4. 燕山大学 国家冷轧板带装备及工艺工程技术研究中心, 河北 秦皇岛 066004
  • 收稿日期:2016-04-30 出版日期:2017-04-28 发布日期:2017-04-26
  • 作者简介:喇东升(1980-),男,副教授,E-mail:ladongsheng@163.com.
  • 基金资助:
    国家自然科学基金项目(61501100,61601105);河北省高等学校科学技术研究项目(QN20132014,QN2015141);中央高校基本科研业务费项目(N142303003);毫米波国家重点实验室开放课题(K201705);河北省自然科学基金项目(F2015203373)

Compact Parallel Coupled Line Band-Pass Filter Design with Open Stub

LA Dong-sheng1,2, GUO Jing-wei3, LIU Yan4, JIA Shou-qing1, MA Xue-lian1   

  1. 1. School of Computer Science and Engineering, Northeastern University, Shenyang 110819, China;
    2. State Key Laboratory of Millimeter Waves, Southeast University, Nanjing 210096, China;
    3. School of Information Science and Engineering, Yanshan University, Hebei Qinhuangdao 066004, China;
    4. National Engineering Research Center for Equipment and Technology of CSR, Yanshan University, Hebei Qinhuangdao 066004, China
  • Received:2016-04-30 Online:2017-04-28 Published:2017-04-26

摘要: 为了解决耦合线滤波器谐波抑制问题,提出了一种新的结构简单的平行耦合线带通滤波器.该滤波器由平行耦合线和开路枝节组成.首先基于耦合线带通滤波器的等效电路图,通过奇偶模理论得到设计方程,并设计了带通滤波器;分析了滤波器特性与电参数之间的关系;通过仿真优化得到了滤波器的物理尺寸;制备并测试了滤波器的S参数,仿真结果和测试结果基本一致.该滤波器具有结构简单、面积小等优点,并通过引入传输零点实现了较宽的阻带抑制和较好的选择性.

关键词: 带通滤波器, 平行耦合线, 开路枝节, 奇偶模理论, 半波长

Abstract: In order to solve harmonic suppression, a parallel coupled line band-pass filter with simple structure was proposed. The filter consists of parallel coupled lines and open stubs. Filter's equation was firstly obtained via odd-even mode analytical method, which is based on the equivalent circuit of the proposed coupled line band-pass filter, and a compact band-pass filter was designed. Secondly, the relationship between filter's resonant characteristics and its electrical parameters was analyzed. And then, the geometric parameters of the proposed band-pass filter was obtained and optimized. Finally, the proposed band-pass filter and measured its S parameters was fabricated, which were basically consistent with simulation. It is founded that the filter designed has the advantages of simple structure, small size, etc. The proposed band-pass filter also has a wide stop band rejection and better selectivity through the introduction of transmission zeros.

Key words: bang-pass filter, parallel coupled line, open stub, odd-even mode analytical method, half wavelength

中图分类号: